STEERING WHEEL
Quick Release Snap-Fit Universal

Approved by SFI

The Snap-fit ​​is produced 100% in aluminum, has two parts, one is the body that must be fixed to the steering wheel (gray trigger), the other is the pinion that has a base with 6 holes that must be fixed to the hub of the respective vehicle (access the Cube List). This cube must be purchased separately, and may be made by Lotse, or even imported. The locking system uses 3 balls, and the fitting takes place in the same position in which it was removed.

65MM LENGTH (total connected parts)

SNF-UN (Fixed Cube is purchased separately)

ATTENTION: The Snapfit is a piece intended for use on the slopes.

ATTENTION: Never use extensions between the steering wheel and the Snap-Fit Universal.